STARTING SYSTEM — STARTER Disassembly / Assembly (B6 DOHC), Drive pinion Notes

G-39parts diagram

Exploded view is B6 DOHC. Assembly Note step 1 notes drive pinion sets onto the armature for B6 DOHC or onto the gear shaft for K8 DOHC MTX.

Parts DiagramFig. fig1

#	Part Name	Notes
1	Magnetic switch	Inspection ... page G-40
2	Rear bracket	—
3	Brush holder assembly	Inspection ... page G-40
4	Yoke	Inspection ... page G-41
5	Front bracket	—
6	Lever	—
7	Drive pinion	Disassembly Note ... below; Assembly Note ... below
8	Armature	Inspection ... page G-41
9	Bearing (if equipped)	—

Disassembly Note

Remove the stopper for the overrunning clutch with a pipe as shown in the figure.

1
Set the drive pinion onto the armature (B6 DOHC) or gear shaft (K8 DOHC MTX), and install the ring.
2
Install the stopper with the SST and press as shown in the figure.