ANTI-LOCK BRAKE SYSTEM

P-63prose procedure

Main fuse block layout differs between K8 (1.8L V6) and B6 (1.6L I4) engines.

1
Disconnect the ABS hydraulic unit connector (6 pin).
2
Measure the resistance between following terminals. 4f-4a, 4b; 4e-4c, 4d
3
If not as specified, check the ABS hydraulic unit wiring harness or replace the ABS hydraulic unit if necessary.

Specification	Value
Resistancebetween terminals 4f-4a/4b and 4e-4c/4d	approx. 3Ω

Resistancebetween terminals 4f-4a/4b and 4e-4c/4d

approx. 3Ω

Check fuse

Check the fuses according to the following table. If a fuse is burned, replace it.

Fuse name	Rating (Amp)	Location	Failure condition	Refer to
ABS PUMP	60	Main fuse box	ABS warning light illuminates (Diagnostic trouble code 51 or 53); ABS motor and solenoid valves do not operate	P-58, 59
MAIN	100	Main fuse box	Engine does not start	—
ABS	10	Fuse panel (at driver's side)	ABS warning light illuminates after engine started; ABS control module not activated	—
STOP	20	Fuse panel (at driver's side)	Brake light does not illuminate	—
METER	15	Fuse panel (at driver's side)	ABS warning light does not illuminate	—

ABS PUMP

Rating (Amp)60

LocationMain fuse box

Failure conditionABS warning light illuminates (Diagnostic trouble code 51 or 53); ABS motor and solenoid valves do not operate

Refer toP-58, 59

MAIN

Rating (Amp)100

LocationMain fuse box

Failure conditionEngine does not start

Refer to—

ABS

Rating (Amp)10

LocationFuse panel (at driver's side)

Failure conditionABS warning light illuminates after engine started; ABS control module not activated

Refer to—

STOP

Rating (Amp)20

LocationFuse panel (at driver's side)

Failure conditionBrake light does not illuminate

Refer to—

METER

Rating (Amp)15

LocationFuse panel (at driver's side)

Failure conditionABS warning light does not illuminate

Refer to—