Conventional Brake System - Master cylinder assembly inspection
P-25prose procedureMaster cylinder assembly inspection (continued)
- 3Install a radiator cap tester and the SSTs to the front port on the master cylinder. Apply air into the master cylinder and verify that the air pressure is not built.
- 4Tighten the adjustment bolt on the SST until the gap A' becomes 11 mm {0.433 in}. Raise the air pressure 49.05 kPa {0.5 kgf/cm2, 7.11 psi} and verify that the pressure is held for more than 5 seconds.
- 5Check for the rear port on the master cylinder by using same procedure.
| Specification | Value |
|---|---|
| Gap A' | 11mm {0.433 in} |
| Air pressureheld more than 5 seconds | 49.05kPa {0.5 kgf/cm2, 7.11 psi} |
Gap A'
11mm {0.433 in}
Air pressureheld more than 5 seconds
49.05kPa {0.5 kgf/cm2, 7.11 psi}