Conventional Brake System — Rear Brake (Drum): Quick Inspection & Removal / Inspection / Installation
P-42parts diagramREAR BRAKE (DRUM)
Quick Inspection (On-vehicle)
Rear Drum Brake Quick Inspection (On-vehicle)
- 1Jack up the rear of the vehicle and support it with safety stands.
- 2Remove the plug as shown in the figure, then inspect the thickness of the brake lining through the inspection hole.
- 3Replace if below the limit.
| Specification | Value |
|---|---|
| StandardBrake lining thickness | 4.0mm {0.16 in} |
| MinimumBrake lining thickness | 1.0mm {0.04 in} |
StandardBrake lining thickness
4.0mm {0.16 in}
MinimumBrake lining thickness
1.0mm {0.04 in}
Removal / Inspection / Installation
Rear Drum Brake Removal / Inspection / Installation
- 1Remove the lining in the order shown in the figure, referring to Removal Note.
- 2Inspect all parts and repair or replace as necessary.
- 3Install in the reverse order of removal, referring to Installation Note.
Parts DiagramFig. fig2