Conventional Brake System - Piston assembly, Grommet/reserve tank/tank retainer, Inspection
P-24prose procedurePiston assembly (continued)
- 9Measure clearance between the cylinder body flange and the cap.
- 10If the clearance is greater than specified, disassemble and reassemble the master cylinder.
| Specification | Value |
|---|---|
| Clearance (cylinder body flange to cap)max | 14.4mm {0.567 in} |
Clearance (cylinder body flange to cap)max
14.4mm {0.567 in}
Grommet, reserve tank, tank retainer
- 1Install the new grommet to the reserve tank.
- 2Install the reserve tank to the cylinder.
- 3Install the tank retainer while pushing the reserve tank to the cylinder body.
Inspection
Master cylinder assembly
Master cylinder assembly inspection
- 1Set the SST as shown in the figure, tighten the nut to the specified torque.
49 Z043 0A0 - 2Turn the adjusting bolt until gap A is 21 mm {0.83 in}.
| Specification | Value |
|---|---|
| Tightening torque (nut) | ≈97 - 153N·m |
| Gap A | 21mm {0.83 in} |
Tightening torque (nut)
97 - 153N·m
Gap A
21mm {0.83 in}