ANTI-LOCK BRAKE SYSTEM — Memory Cancel / Diagnostic Trouble Code Table
P-56spec tableMemory Cancel
Diagnostic trouble codes memorized in the ABS control module are canceled by performing the following steps.
Memory Cancel
- 1Connect the TBS terminal to GND at the data link connector.
- 2Turn the ignition switch ON.
- 3Output all memorized codes.
- 4After verifying that the first code is repeated, depress the brake pedal 10 times at intervals of less than one second (1 sec.).
NOTE
Diagnostic trouble codes will not be canceled if:
Intervals of depressing the brake pedal exceed one second (1 sec.).
Brake switch has failed.
While performing the memory cancel operation, the ABS warning light will illuminate.
After memory cancel, the ABS control module will perform on-board diagnosis.
Diagnostic Trouble Code Table
Diagnostic Trouble Code Table
11
Possible causeRight front ABS wheel-speed sensor; Right front ABS sensor rotor
Pattern of output signal (On-Board Diagnosis Checker)Code 11 pulse pattern (1 long + 1 short)
Diagnosis chart No.ABS-1
12
Possible causeLeft front ABS wheel-speed sensor; Left front ABS sensor rotor
Pattern of output signal (On-Board Diagnosis Checker)Code 12 pulse pattern (1 long + 2 short)
Diagnosis chart No.ABS-1
13
Possible causeRight rear ABS wheel-speed sensor; Right rear ABS sensor rotor
Pattern of output signal (On-Board Diagnosis Checker)Code 13 pulse pattern (1 long + 3 short)
Diagnosis chart No.ABS-1
14
Possible causeLeft rear ABS wheel-speed sensor; Left rear ABS sensor rotor
Pattern of output signal (On-Board Diagnosis Checker)Code 14 pulse pattern (1 long + 4 short)
Diagnosis chart No.ABS-1
15*
Possible causeABS wheel-speed sensor
Pattern of output signal (On-Board Diagnosis Checker)Code 15 pulse pattern (1 long + 5 short)
Diagnosis chart No.ABS-2
22
Possible causeRight front solenoid valve
Pattern of output signal (On-Board Diagnosis Checker)Code 22 pulse pattern (2 long + 2 short)
Diagnosis chart No.ABS-3
24
Possible causeLeft front solenoid valve
Pattern of output signal (On-Board Diagnosis Checker)Code 24 pulse pattern (2 long + 4 short)
Diagnosis chart No.ABS-3
26
Possible causeRight rear solenoid valve
Pattern of output signal (On-Board Diagnosis Checker)Code 26 pulse pattern (2 long + 6 short)
Diagnosis chart No.ABS-3
28
Possible causeLeft rear solenoid valve
Pattern of output signal (On-Board Diagnosis Checker)Code 28 pulse pattern (2 long + 8 short)
Diagnosis chart No.ABS-3
NOTE
*If the ignition switch is turned OFF and then ON again, and the vehicle is then accelerated to higher than 10km/h {6.2MPH}, diagnostic trouble code 15 will be replaced by a code from 11 through 14.