CONVENTIONAL BRAKE SYSTEM - MASTER CYLINDER (K8 DOHC)
P-21prose procedureAfter tightening the brake pipe
- 5After tightening the brake pipe: (1) Add brake fluid and bleed the air. (Refer to page P-7.) (2) Check the brake lines for fluid leakage. (Refer to page P-9.)
Inspection
Fluid level sensor
Fluid level sensor Inspection
- 1Disconnect the sensor connector.
- 2Connect an ohmmeter to the connector.
- 3Starting with the fluid level above MIN mark on the reservoir, verify that there is no continuity.
- 4Remove the brake fluid and verify continuity when the level is below the MIN mark.
- 5Replace the sensor if necessary.