CONVENTIONAL BRAKE SYSTEM
P-43prose procedureRemoval Note
Brake drum
NOTE
If the brake drum is hard to remove, secure the stopper until the operating lever returns to release the sticking of the brake drum.
Brake pipe
Disconnect or connect the brake pipe from/to the wheel cylinder by using the SST.
| Specification | Value |
|---|---|
| brake pipe to wheel cylinder | 16 - 21N·m |
brake pipe to wheel cylinder
16 - 21N·m
Inspection
Check for the following and repair or replace as necessary.
Brake drum
Brake drum inspection
- 1Drum inner diameter
- 2Scratches, uneven or abnormal wear inside drum.
| Specification | Value |
|---|---|
| Standard diameterdrum inner diameter | 200.0 mm {7.874 in}mm |
| Diameter limitdrum inner diameter | 201.0 mm {7.913 in}mm |
Standard diameterdrum inner diameter
200.0 mm {7.874 in}mm
Diameter limitdrum inner diameter
201.0 mm {7.913 in}mm
Installation Note
Grease points
(1) Piston of wheel cylinder
(2) Anchor sliding parts
(3) Projection of backing plate
(4) Adjusting screw
(5) Adjusting sleeve contact surfaces
Brake drum
Brake drum installation
- 1Before installing the brake drum, depress the brake pedal to verify operation of the automatic adjuster.
- 2Install the brake drum.