SLIDING SUNROOF — Adjustment
S-60prose procedureAdjustment
Slide panel
Height
Adjust the height difference between the slide panel and the roof panel by using the following procedure.
| Specification | Value |
|---|---|
| Allowable height differencemax. | 2.0mm {0.08 in} |
Allowable height differencemax.
2.0mm {0.08 in}
Height adjustment
- 1Remove the headliner. (Refer to page S-70.)
- 2Loosen the set bracket attaching nuts.Clockwise rotation raises the frame.
- 3Turn the height adjusting nuts and adjust the sunroof frame height.
- 4After adjustment, securely install the sunroof frame to the roof panel.
Gap
Gap adjustment
- 1Verify that the slide panel does not interfere with the roof panel when operated.
- 2If it interferes, loosen the slide panel attaching nuts and move the panel as necessary.
- 3If the above adjustment is not enough, loosen the attaching screws and bolts of the sunroof frame and set bracket and carry out adjustment. (Refer to page S-54, Installation note for the sunroof drive unit.)
Moving load
Moving load adjustment
- 1Measure the operation time of the slide panel from fully opened to fully closed or vice versa.
- 2If not as specified, adjust it by turning the locknut on the sunroof motor assembly. (1) Remove the housing cover attaching screw and the E-ring. Remove the housing cover from the motor. (2) Unfold the pole washers indicated by arrows. (3) Hold the motor shaft by using an allen wrench and turn the locknut to adjust the torque. (4) Fold the pole washers.
| Specification | Value |
|---|---|
| Specified timefully opened to fully closed or vice versa | 4—7sec |
Specified timefully opened to fully closed or vice versa
4—7sec