Mazda MX-3 silhouetteMX-3

ROOF MOLDING

S-30prose procedure

Removal / Installation

  1. 1
    Remove in the order shown in the figure.
    Exploded view of the roof showing roof molding removal/installation. Callout 1 (Roof molding) points to two roof side moldings; two inset detail views show the molding cross-section and clip engagement. The upper-right inset (callout 2, Clip) is marked REPLACE. The lower-left inset shows the molding-to-clip cross section (callout 1).
  2. 2
    Install in the reverse order of removal, referring to Installation note.
Parts DiagramFig. fig1
#Part NameNotes
1Roof moldingInstallation note ... below
2ClipREPLACE

Installation note

Roof molding

Roof molding installation note

  1. 1
    Remove the clips from the roof panel.
    Installation-note detail illustration showing the roof panel edge with two clips labeled CLIP and downward arrows indicating clip installation onto the roof panel.
  2. 2
    Clean and degrease the clip installation points.
  3. 3
    Install new clips to the roof panel.
Support our work!

Search Manual

Search pages, specs, and procedures