Mazda MX-3 silhouetteMX-3

SLIDING SUNROOF

S-54prose procedure
Continued from S-53

Removal note

Sunroof trim

  1. 1
    Tilt up the slide panel.
    View of the sunroof trim at the roof opening with an arrow showing it being pulled out from between the slide panel and the roof. Label: SUNROOF TRIM.
  2. 2
    Remove the fasteners on the front side of the sunroof trim.
  3. 3
    Pull down the trim and remove it from the sunroof panel.
  4. 4
    Pull out the sunroof trim from between the slide panel and the roof.

Slide panel

  1. 1
    Fully close the slide panel by using an allen wrench.
    Underside view of the slide panel showing the slide panel fixing nuts (arrows) at the corners to be removed.
  2. 2
    Remove the slide panel fixing nuts. Push up the slide panel from inside and remove it from the lower panel.

Sunroof drive unit

  1. 1
    Remove the bolts C.
    Top view of the sunroof drive unit / frame showing the locations of height adjusting nuts A, nuts B (arrows pointing in from the sides), and bolts C (arrows pointing up from the bottom).
  2. 2
    Loosen the nuts B.
  3. 3
    Loosen the height adjusting nuts A and remove the sunroof drive unit from the body.

Installation note

Sunroof drive unit

  1. 1
    Align the locator pins and set the sunroof drive unit to the roof panel.
    Detail of the sunroof drive unit set onto the roof panel, with Section A-A showing the locator pin engagement. Labels: SUNROOF DRIVE UNIT, LOCATOR PIN, SEC. A-A.
  2. 2
    Loosely install the sunroof drive unit to the roof panel with the height adjusting nuts.
    Detail of the height adjusting nut on the sunroof drive unit installed to the roof panel, with Section A-A. Labels: NUT, SEC. A-A.
Support our work!

Search Manual

Search pages, specs, and procedures