Molding
S-24prose procedureInstallation note — Windshield molding (continued)
- 7If the protector is damaged, replace it with a new one.
- 8Apply primer onto the bonding area of the glass, body, and new windshield molding by using a brush. Use only glass primer on the glass and body primer on the body and molding. Keep the area free of dirt and grease, and do not touch the surface. Allow the primer to dry for approximately 30 minutes.
- 10Apply a 3 mm (0.12 in) bead of repair sealant between the glass and the body.
- 11Reshape the repair sealant as shown if necessary.
- 12Install the windshield molding before the sealant hardens. 1) Align the marks on the molding to the roof inner line. 2) Install the top of the molding. 3) Install the corners of the molding. 4) Install the sides of the molding, starting from the top and then toward the bottom.
- 13Check for water leaks. If a leak is found, wipe the water off well and repeat the installation.
Hardening time of repair sealant
Hardening time of repair sealant
5°C (41°F)
Surface hardening timeApprox. 1.5 hr
Time required until car can be put into service12 hr
20°C (68°F)
Surface hardening timeApprox. 1 hr
Time required until car can be put into service4 hr
35°C (95°F)
Surface hardening timeApprox. 10 min
Time required until car can be put into service2 hr