REAR SUSPENSION (STRUT) — Stabilizer bushing Installation Note; STABILIZER CONTROL LINK
R-36parts diagramInstallation Note — Stabilizer bushing
NOTE
Align the bushing with the installation position line painted on the stabilizer bar.
STABILIZER CONTROL LINK
Removal / Inspection / Installation
- 1Jack up the rear of the vehicle and support it with the safety stands.
- 2Remove the wheels.
- 3Remove in the order shown in the figure.
- 4Visually inspect each part and replace as necessary.
- 5Install in the reverse order of removal.
- 6Install the wheels. (Tightening torque: 89-117 N·m {9.0-12.0 kgf·m, 66-86 ft·lbf})
Parts DiagramFig. fig2
Inspection — Stabilizer control link
- 1Inspect for bending and damage.Check the following and replace if necessary
- 2Shake the ball joint stud 10 times.
- 3Rotate the ball joint stud 10 times.
- 4Measure the preload with a suitable hexagon wrench and a torque wrench. (Preload: 0.2-1.4 N·m {2.0-15.0 kgf·cm, 1.7-13.0 in·lbf})
| Specification | Value |
|---|---|
| Preload (ball joint stud) | 0.2 - 1.4N·m |
Preload (ball joint stud)
0.2 - 1.4N·m