Tie-rod end
M-7prose procedureFRONT AXLE
Tie-rod end
CAUTION
The sharp edges of the SST can slice the tie-rod end dust boot. Install the SST so that the sharp edges are between the dust boot and tie-rod end.
Tie-rod end
- 1Remove the tie-rod end nut.
- 2Disconnect the tie-rod end by using the SST.
49 T028 3A0
Installation Note
Tie-rod end
Tie-rod end installation
- 1Position the tie-rod end and dust boot directly over the knuckle hole.
- 2Install the nut to the tie-rod end and tighten.
- 3Install a new cotter pin.
| Specification | Value |
|---|---|
| Tightening torque (tie-rod end nut) | 43 - 56N·m |
Tightening torque (tie-rod end nut)
43 - 56N·m
Locknut
Install a new locknut and stake it, as shown.
| Specification | Value |
|---|---|
| Tightening torque (locknut) | 236 - 318N·m |
Tightening torque (locknut)
236 - 318N·m