DRIVE SHAFT
M-20prose procedureRemoval Note
Tie-rod end
CAUTION
The sharp edges of the SST can slice the tie-rod end boot. Install the SST so that the sharp edges are between the dust boot and tie-rod end.
Tie-rod end
- 1Remove the tie-rod end nut.
- 2Disconnect the tie-rod end by using the SST.
Right drive shaft and axle
CAUTION
Be careful not to damage the ball joint dust boot.
Right drive shaft and axle
- 1Remove the clinch bolt and nut.
- 2Pry down on the lower arm to disconnect the ball joint.
- 3As shown in the figure, insert a pry bar between the drive shaft and the joint shaft and tap on the bar to uncouple them.
Joint shaft
Pull the joint shaft straight out.