REAR AXLE — Hub bolt Disassembly/Assembly Note; Disc Brake Type Preinspection / Replacement

M-14prose procedure

Disc brake type section (vs drum brake type on M-11).

Disassembly Note

NOTE

The hub bolts do not need to be removed unless you are replacing them.

Remove the hub bolts with a press.

Press in new hub bolts.

1
Remove the wheel and tire.
2
Remove the brake caliper assembly.
3
Position a dial indicator against the wheel hub. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play.
4
If the bearing play exceeds specification, check and adjust the locknut torque or replace the hub bearing assembly if necessary.

Specification	Value
Maximum wheel bearing play	0.05 mm {0.002 in}

Maximum wheel bearing play

0.05 mm {0.002 in}

1
Remove the wheel hub bolt by using the SSTs.
2
As shown in the figure, install the wheel hub bolt into the wheel hub and set a washer and wheel hub nut in the wheel hub bolt.
3
Tighten the wheel hub nut while holding the wheel hub by using the brass bar.