Mazda MX-3 silhouetteMX-3

Clutch Release Cylinder

H-13prose procedure

Exploded view labeled B6 DOHC.

Preparation

SST

SST

49 0259 770B
NameWrench, flare nut
UsageFor disconnecting/connecting clutch pipe

Removal / Installation

Removal / Installation

  1. 1
    Remove in the order shown in the figure, referring to Removal Note.
    Exploded view of the clutch release cylinder installation (B6 DOHC). A magnified inset at left shows the release cylinder with bleeder screw; callout 3 points to the clutch release cylinder, callout 1 (with SST) to the clutch pipe with torque 12.6-21.5 N·m (130-220 kgf·cm, 113-190 in-lbf), callout 2 to the mounting bolt with torque 19-25 N·m (1.9-2.6 kgf·m, 14-18 ft-lbf). A molybdenum sulfide grease application point is indicated at the cylinder rod tip.
  2. 2
    Install in the reverse order of removal, referring to Installation Note.
  3. 3
    After installation, bleed the clutch system. (Refer to page H-9.)
Parts DiagramFig. fig2
#Part NameNotes
1Clutch pipeRemoval Note ... below; Installation Note ... page H-14
2Bolt—
3Clutch release cylinderRemove boot and check for fluid leakage; Overhaul ... page H-14

Removal Note

Clutch pipe

Disconnect the clutch pipe by using the SST, and plug the clutch pipe immediately.
Support our work!

See also

page H-9page H-14

Search Manual

Search pages, specs, and procedures