Mazda MX-3 silhouetteMX-3

PRE-DELIVERY INSPECTION

A-2prose procedure

ATX = automatic transaxle; MTX = manual transaxle. Several items are option-dependent (if equipped).

PRE-DELIVERY INSPECTION TABLE

The following items may be done at any time prior to delivery to your customer.

EXTERIOR

INSPECT and ADJUST, if necessary, the following items to specification: - Glass, exterior bright metal, and paint for damage - Wheel lug nuts and locks (if equipped) 89–117 N·m {9–12 kgf·m, 66–86 ft·lbf} - All weatherstrips for damage or detachment - Operation of hood release and lock - Operation of rear hatch, and fuel lid opener - With trunk open, check for spare jack, tire, tools, and fasteners securing these items in place. - Door operation and alignment - Headlight aim INSTALL the following parts: - Wheel caps or rings (if equipped)

UNDER HOOD-ENGINE OFF

INSPECT and ADJUST, if necessary, the following items to specification: - Fuel, coolant and hydraulic lines, fittings, connections, and components for leaks - Engine oil level - Power steering fluid level - Brake and clutch master cylinder fluid level - Windshield washer reservoir fluid level - Radiator coolant level - Tightness of battery terminals - Manual transaxle oil level

INTERIOR

INSTALL the following parts: - Rubber stopper for rearview mirror CHECK operation of the following items: - Seat controls (slide and recline) and headrests - Folding rear seat - Door locks - Seat belts and warning system - Ignition switch and steering lock - Transaxle range switch (ATX only) - Starter interlock switch (clutch pedal, MTX only) - All lights, including warning and indicator lights - Sound warning system - Horn, wipers, and washers (front and rear, if equipped) - Audio system (if equipped) - Cigarette lighter and clock
- Sliding sunroof (if equipped) - Power door lock (if equipped) - Power outside mirrors (if equipped) - Power windows (if equipped) - Heater, defroster, and air conditioner at various mode selections (if equipped) CHECK the following items: - Presence of spare fuses - Upholstery and interior finish CHECK and ADJUST, if necessary, the following items: - Pedal height and free play of brake and clutch pedal

Pedal height and free play

Clutch pedal
Pedal height mm {in}199–204 {7.83–8.03} (With carpet)
Free play mm {in}5–16 {0.19–0.63}
Brake pedal
Pedal height mm {in}193–196 {7.60–7.72}
Free play mm {in}4–7 {0.16–0.28}
- Parking brake 5–7 notches/98 N {10 kgf, 22 lbf}

UNDER HOOD-ENGINE RUNNING AT OPERATING TEMPERATURE

CHECK the following items: - Automatic transaxle fluid level

ON HOIST

CHECK the following items: - Underside fuel, coolant and hydraulic lines, fittings, connections, and components for leaks - Tires for cuts or bruises - Steering linkage, suspension, exhaust system, and all underside hardware for looseness or damage

ROAD TEST

CHECK the following items: - Brake operation - Clutch operation - Steering control - Operation of gauges - Squeaks, rattles or unusual noises - Emergency locking retractors - Cruise control system (if equipped)

AFTER ROAD TEST

CHECK for owner information materials.
The following items must be done just before delivery to your customer. - Load test battery and charge if necessary (Load test result: ___ Volts) - Adjust tire pressure to specification (Refer to door label) - Clean outside of vehicle - Install fuses for accessories - Remove seat and cabin carpet protective covers - Vacuum and clean interior of vehicle - Inspect installation of optional parts

Search Manual

Search pages, specs, and procedures